Thursday, 26 November 2009

Plans afoot

Spent a few hours yesterday with QCAD and I now have a plan for the swinging arm.

I've had to extend the swingarm by an inch to make sure everything fits without clearance issues. This may not have been completely necessary as I've found out that the TZR wheel I used to figure everything out is over-tyred (130/80 vs 120/80) but it's always better to have a bit too much tyre clearance than too little.

Hopefully I'll get the arm soon then I can see if I need to cut the pillion footrest loops off (It's close).

No comments:

Post a Comment